- More Sanding and Bondo Outer Hull2
- More Sanding and Bondo Outer Hull3
- New Piece of Nomex on Port Side
- Outer hull sanded and ready for Bondo
- Outer structure finally really done
- Peel Ply over epoxied Kevlar
- Pin hole filled and new layer of fiberglass applied then wrapped
- Port Side Sanded
- Port side de-lamination fixed
- Port side ready for first application of epoxy
- Port side sanded and ready for Bondo - and found another small pin hole closer to bow
- Port side sanded and ready for last layer
- Port side structural repair complete
- Port side wrapped for first time
- Primer on Outer Hull
- Ready for wax paper port side
- Ready to join deck and fix some cracks in top of deck
- Readying vacuum bag
- Realizing Release Film is not the right stuff and wont create vacuum
- Release Film
- Result of repair to deck seams and first half of cracks
- Sanded Bondo and Touch Up on Outer Hull1
- Sanded Bondo and Touch Up on Outer Hull2
- Sanding carbon and epoxy as smooth as we can
- Second deck section done and sanded
- Second half of top deck cracks sanded
- Soft areas glued down
- Starboard Side Sanded for Gluing Down Soft Areas
- Starboard side ready for Bondo
- Starboard side ready for last layer
- Starboard side soft areas glued and clamped
- Starboard side structural repair complete
- Stern deck tabs in place
- Thin epoxy to lay carbon for keel
- Third section epoxied - center spine
- Vacuum Bag on Bulkhead
- Wax paper onto keel
- Wax paper port side
- Wax paper starboard side
- West Systems Epoxy
- laying in Kevlar cloth1
- laying in Kevlar cloth2